AJAX vhfBridge LITE ( no case) Module for connecting Ajax security systems to third-party VHF transmitters..

AJAX vhfBridge Module for connecting Ajax security systems to third-party VHF transmitters..

The INT-RX-S expander is dedicated for cooperation with the alarm control panels from the series INTEGRA, VERSA, PERFECTA and the system ACCO NET. Device allows to use the 433MHz remote control keyfobs to control the alarm system. 433MHz keyfob receiver permits the use of remote control keyfobs to control the alarm system. It makes the control of ..

- high-current AC/DC appliance control - triggering with low-current OC outputs - 4 relays - 5 fuses..

Wireless two-channel 230 V AC in-wall controller. The ASW-210 module is designed to remotely switch on/off devices powered from 230 V AC mains. It operates as part of the Satel ABAX 2/ABAX two-way wireless system...

The MTX-300 controller enables expansion of the alarm systems by adding wireless devices that operate at 433 MHz frequency. It can work in conjunction with SATEL control panels, including: INTEGRA, INTEGRA Plus, VERSA and VERSA Plus, as well as MICRA module. It can also be used in any third-party alarm system or automation system, e.g. as a radio c..

The VERSA-MCU module enables expansion of the VERSA control panels with wireless 433MHz detectors. Up to 30 detectors may be added to a VERSA panel using this module. Owing to its compact casing, the VERSA-MCU module may be easily installed in an optimum location. - supports up to 30 MICRA system detectors - supports 433 MHz pilots - dedicated for ..

ACU-220 uses the 868 MHz radio band, in which 4 channels have been allocated. Communication between components of the ABAX 2 system is encrypted (AES standard) and two-way, all transmissions being acknowledged. The controller works together with the INTEGRA, INTEGRA Plus and VERSA control panels (connection via communication bus), making expansion ..

ABAX 2 wireless system controller ACU-280 provides two-way, encrypted (AES standard) communication in the 868 MHz band - all radio transmissions between components of the ABAX 2 system are acknowledged. It works together with the INTEGRA, INTEGRA Plus and VERSA control panels, enabling wireless devices to be added to the alarm system. Because of i..

ARU-200 radio signal retransmitter receives transmissions from ABAX 2 wireless devices and retransmits them. ARU-200 can extend the range of the ABAX 2 system wireless communication...

The MRU-300 radio signal repeater receives transmissions from MICRA wireless devices and retransmits them. It works with the PERFECTA control panels (WRL models), VERSA-MCU controller, MTX-300 controller, MICRA alarm module (firmware version 2.02 or newer). - support for the following MICRA wireless system devices: -- MFD-300, MGD-300, MMD-300,..

AJAX ReX 2 Radio signal range extender supporting photo verification of alarms..

AJAX ReX 2 Radio signal range extender supporting photo verification of alarms..

Zone and output expansion module - support for: NO, NC EOL, 2EOL/NO, 2EOL/NC (alarm control panels only) 3EOL (INTEGRA Plus only) - support for roller shutter and vibration detectors (alarm control panels only) - system expansion with 8 zones - system expansion with 8 outputs: 4 OC type outputs 4 relay outputs - ability to connect..

The ACX-210 module makes it possible to use wired devices (detectors, sirens, etc.) in the ABAX 2/ABAX wireless system. It has 4 programmable zones with support for the NO and NC type wire detectors and EOL, 2 EOL configurations, as well as 4 programmable OC type wired outputs. ACX-210 settings are configured and its firmware updated remotely. In ..